HURON™ 4'
RECESS BATH
ENAMELED STEEL
HURON™ 4' RECESS BATH
❏ 0131.012 Right hand outlet
❏ 0133.017 Left hand outlet
Product Features:
• Acid resisting, enameled steel construction
• One-piece recess bath
• Integral apron
• End drain outlet
• Full slip-resistant surface
• Straight tiling flange
Nominal Dimensions:
1181 x 686 x 394mm
(46-1/2" x 27" x 15-1/2")
SEE FITTING SPECS.
FOR DIMENSION
C/L OF
SUPPLIES
Compliance Certifications -
C/L OF
SHOWER ARM
22mm
(7/8)
Meets or Exceeds the Following Specifications:
• ASME A112.19.4 for Enameled Steel Plumbing
Fixtures
19mm
(3/4)
OPTIONAL TO FINISHED FLOOR
(USUALLY BETWEEN 1651mm (65)
& 1981mm (78)
191mm
(7-1/2)
• ASTM F-462 for Slip-resistant Bathing Facilities
229mmx305mm
(9x12) FLOOR
CUTOUT FOR
DRAIN
FINISHED
WALL
1181mm
(46-1/2)
FINISHED
WALL
104mm
(4-1/16)
C/L OF
VALVE
51mm
(2)
To Be Specified:
❏ Color:
❏ Bath Faucet*:
❏ Faucet Finish:
❏ Drain:
C/L OF
SPOUT
327mm
(12-7/8)
305mm
(12)
25mm
(1)
67 mm
(2-5/8)
102mm
(4)
* See faucet section for additional models available
19mm
(3/4)
19mm
(3/4)
394mm
(15-1/2)
686mm
(27)
ROUGH
FLOOR
PLUMBER NOTE –
PROVIDE SUITABLE SUPPORT AT THIS POINT
76mm
(3)
38mm
(1-1/2)
1-1/2 N.P.T.
THREADS
1-1/2 O.D.
TAILPIECE
NOTES:
0133.017 LEFT HAND OUTLET (SHOWN).
0131.012 RIGHT HAND OUTLET (REVERSE DIMENSIONS).
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH BATH FOR
ADDITIONAL INFORMATION.
SHOWN WITH POP-UP C.D. & O.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
CONCEALED PIPING NOT INCLUDED.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range
of tolerances established by ANSI Standard A112.19.4. These measurements
are subject to change or cancellation. No responsibility is assumed for use of
superseded or voided leaflet.
H164
© 2008 AS America Inc.
Revised 2/08
|