Product Application
Operation
Bluetooth Wireless Speaker
Quick Start Guide
Charging the battery
The battery is not fully charged and it is highly recommended that you charge ABS03F
before you begin using it.
Speaker - 3W sound output
Charge the built-in
lithium ion battery
with the included
USB cable
On - Off switch
Note: Using ABS03F “out of the box” will not harm the device. You will experience reduced battery
life as the unit will not be fully charged.
Connect the larger USB end of the cable provided to your PC / power adapter.
Connect the smaller USB end to charging port of ABS03F. Please charge the battery
for a minimum of (4) hours. The Red LED will be on while charging. When charging
is complete, the red LED will turn off.
Function
Volume +
Operation
Press for 1 second to advance to next song. Press and hold to
increase the volume.
Connect any MP3
Player with a
3.5mm auxiliary
audio output
Press for 1 second to advance to previous song. Press and hold
to decrease the volume.
Volume -
Speaker controls and LED
ABS03F
Skid free base
Tech Support & Warranty Information
aluratek.com
qsg Q10265 Copyright © 2012 Aluratek, Inc. All Rights Reserved.
Operation
Radio and TV Interference Statement
Note: The pairing mode will last for 3 minutes. If the pairing failed within 3 minutes, the system will
search for the last paired device and the blue LED will flash slowly. To restart the pairing process,
turn off the speaker and power on again.
If you need further assistance, please contact the Aluratek support department for
troubleshooting prior to returning this device.
WARNING!!! This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
Pairing with the transmitter such as iPhone, smart phone, and tablet:
The pairing procedure will vary depending on the actual device. Please refer to the
user guide of your device for detail instruction. The general pairing procedures are
as follows:
E-mail: [email protected]
Local (Tustin, CA): 714-586-8730
Toll free: 1-866-580-1978
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by whatever measures may be
required to correct the interference.
1. Make sure ABS03F is turned ON.
2. ABS03F will enter pairing mode automatically after 10 seconds.
(you will hear 3 audio tones and the blue LED will flash rapidly)
3. Activate your device’s Bluetooth function and set your device to search for Bluetooth
devices. Select ABS03F when it is found.
Aluratek warrants this product against defect in material or workmanship for
1 Year from the date of purchase.
4. For transmitter with Bluetooth version 2.1, you will not need to input a code. If you
are prompted for PIN, please enter “0000”.
5. If prompted by your device to connect, please select “Yes”.
6. After connecting successfully, the blue LED will flash every 3 seconds.
For more information, please visit: http://aluratek.com/warranty-return-policy
Note: Please make sure the audio output is set to Bluetooth / ABS03F for audio streaming from the device.
|