DIGITAL REVERB DR600
Thank you for showing your confidence in us by purchasing the BEHRINGER DIGITAL
REVERB DR600. This ultimate effects pedal is specifically designed to deliver 24-bit high-
resolution stereo reverbs comparable to state-of-the-art studio processors. Thanks to
six renowned modes and extensive parameter control for maximum creativity you’ll have
plenty of cool sounds at your disposal for every situation.
1. CONTROLS
Top view
The LEVEL control adjusts the output level.
The TONE control allows you to shape your overall sound.
The TIME control determines the reverb time.
The MODE control lets you chose between six different reverb sounds:
SPRING: Simulates classic spring reverberation.
PLATE: Simulates the sound of plate reverberation.
HALL: Very bright reverb that simulates the reflections of a concert hall.
GATE: This effect synthetically cuts off reverberation after a period of time.
ROOM: Clearly hear natural room acoustics.
MODULATE: By detuning the reverb tail it creates spacious, almost choir-like
reverb that reminds a little bit of a chorus effect.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use the two 1/4" TS connectors IN A and IN B to plug in a stereo input signal. For
mono use just plug in IN A.
The two 1/4" TS connectors OUT A and OUT B send the signal to your amp. Use both
connectors if you want to achieve full stereo effect. For mono use just plug in OUT A.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
ꢀ
The DR600 has no on/off switch. As soon as you insert the jack into the IN
connector, the DR600 begins running. When not using the DR600, remove
the jack from the IN connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
DIGITAL REVERB DR600
Responsible party name:
Address:
MUSIC Group Services USA, Inc.
18912 North Creek Parkway,
Suite 200 Bothell, WA 98011,
USA
Phone/Fax No.:
Phone: +1 425 672 0816
Fax: +1 425 673 7647
DIGITAL REVERB DR600
complies with the FCC rules as mentioned in the following paragraph:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by MUSIC Group
can void the user’s authority to use the equipment.
behringer.com
|