Amana Battery Charger BC TRM User Manual

En g lish  
3-082-362-11(1)  
Ma in t e n a n ce  
WARNING  
To prevent fire or shock hazard, do not expose the unit to  
rain or moisture.  
• Wipe the unit with a soft dry cloth when it's dirty.  
• When the unit is very dirty, wipe it using a cloth with a little  
neutral solvent added, and then wipe it dry again.  
• Do not use thinners, benzine, alcohol, etc., as they will damage  
the surface of the unit.  
Ba t t e ry ch a rg e r  
• When you use chemical cleaning clothes, refer to their  
instructions mannual.  
• Using a volatile solvent like an insecticide, or keeping the unit  
touching a rubber or vinyl plastic products for a long time may  
cause a deterioration or damage of the of the unit.  
Operating instructions  
Mode demploi  
To Ch a rg e t h e Ba t t e ry Pa ck  
Charging by attaching the battery pack to this unit.  
1
Fit the battery pack to this unit and slide the battery pack  
in the direction of the allow . (See Illustration A)  
Align the end surface of the battery pack shown by the V  
mark to the edge of the terminal shutter of this unit.  
Pull the pow er plug up, and then connect it to a w all  
outlet. (See Illustration B)  
This symbol is intended to alert the user to the  
presence of uninsulated “Dangerous voltage”  
within the products enclosure that may be of  
sufficient magnitude to constitute a risk of  
electric shock to persons.  
Ow n e r’s Re co rd  
2
The model and serial numbers are located on the bottom.  
Record the serial number in the space provided below. Refer  
to these numbers whenever you call upon your Sony dealer  
regarding this product.  
The CHARGE lamp (orange) will light and charging will  
begin.  
When the CHARGE lamp goes out, normal charge is  
completed (Normal charge).  
For a full charge, which allows you to use the battery longer  
than usual, leave the battery pack in place for approximately  
one hour (Full charge).  
This symbol is intended to alert the user to the  
presence of important operating and  
maintenance (servicing) instructions in the  
literature accompanying the appliance.  
Model No. BC-TRM  
Serial No.  
BC-TRM  
Do not connect the power plug of this unit by letting the plug  
side down. (See Illustration C)  
CAUTION  
You are cautioned that any changes or modifications not  
expressly approved in this manual could void your authority to  
operate this equipment.  
Sony Corporation © 2003 Printed in Japan  
To re m o ve t h e b a t t e ry p a ck  
Slide it in the direction opposite to the operation when you  
attach it to this unit, and lift the battery pack above.  
• The BC-TRM battery charger can only be used to charge  
a lithium ion type “InfoLITHIUM” battery pack (M  
series).  
• Unable to use this unit to charge a nickel cadmium type,  
or nickel metal hydride type battery pack.  
• “InfoLITHIUM” M series battery packs have the  
mark.  
NOTE  
Ch a rg in g t im e  
The following table shows the charging time for the battery pack  
which is discharged completely.  
This equipment has been tested and found to comply with the  
limits for a Class B digital device, pursuant to Part 15 of the FCC  
Rules. These limits are designed to provide reasonable  
protection against harmful interference in a residential  
installation. This equipment generates, uses, and can radiate  
radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful  
interference to radio communications.  
However, there is no guarantee that interference will not occur  
in a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of  
the following measures:  
Battery  
Pack  
NP-FM30 NP-FM50 NP-FM70/ NP-QM71/ NP-FM90  
NP-FM91/  
QM91/QM91D  
QM70  
QM71D  
• “InfoLITHIUM” is a trademark of Sony Corporation.  
Full  
charging  
time  
• Le chargeur de batterie BC-TRM ne peut être utilisé que  
pour la recharge de batteries au lithium-ion de type  
« InfoLITHIUM » (modèle M).  
• Ce chargeur ne peut pas être utilisé pour charger les  
batteries au nickel-cadmium ou aux hydrures  
métalliques de nickel.  
210  
280  
500  
580  
720  
830  
Normal  
charging (150)  
(220)  
(440)  
(520)  
(660)  
(770)  
time  
• Approximate minutes to charge an empty battery pack fully  
(Full charge).  
Numbers in parentheses indicate the time when you charge  
normally (Normal charge).  
• To ascertain the battery life, refer to the instruction mamual of  
the video equipment which you use.  
• The charging time may differ depending on the condition of  
the battery pack or the temperature of the environment.  
• Les batteries rechargeables « InfoLITHIUM » de série M  
portent la marque  
.
• « InfoLITHIUM » est une marque de fabrique de Sony  
Corporation.  
– Reorient or relocate the receiving antenna.  
– Increase the separation between the equipment and receiver.  
– Connect the equipment into an outlet on a circuit different  
from that to which the receiver is connected.  
– Consult the dealer or an experienced radio/ TV technician for  
help.  
A
Ch a rg in g t e m p e ra t u re  
The temperature range for charging is 0°C to 40°C (32°F to  
104°F). However, to provide maximum battery efficiency, the  
recommended temperature range when charging is 10°C to  
30°C (50°F to 86°F).  
V mark  
Battery  
pack  
WARNING  
To avoid electrical shock, do not open the cabinet.  
Refer servicing to qualified personnel only.  
CHARGE  
lamp  
To u se t h e b a t t e ry p a ck q u ickly  
No t e s o n Use  
Pre ca u t io n s o n Use  
• Connect the battery charger to an available wall outlet. Even  
though the CHARGE lamp of this unit is off, the battery  
charger is not disconnected from the power source. If any  
trouble occurs while the unit is in use, unplug the cord from  
the wall outlet to disconnect the power source.  
• Unable to use this unit to charge a nickel cadmium type, or  
nickel metal hydride type battery pack.  
• Attach the battery pack to the unit firmly when you charge the  
battery pack.  
• The battery terminal may be damaged if the battery pack is not  
attached correctly.  
• To protect the battery pack, remove the battery pack from the  
unit within 24 hours after the charging is completed.  
• Do not apply mechanical shock or drop the unit.  
• Keep the unit away from a TV or AM receivers.  
In particular, noise from the device may enter a TV or radio if  
it is placed nearby.  
• Unplug the unit from the wall outlet after use. Pull it out by  
the battery charger when unplug this unit. Do not pull it out  
by the battery pack.  
You can remove the battery pack from this unit to use even  
though the charging is not completed yet. However, the time  
that the battery pack can be used differs depending on the  
charging time.  
Terminal  
shutter  
No t e s  
POWER plug  
• Check if the battery pack is attached to this unit firmly when  
the CHARGE lamp is not light.  
• When a fully charged battery pack is installed, the CHARGE  
lamp will once light, then go out.  
• When charging a battery pack which is not used for a long  
time period, it may take longer than usual to charge the battery  
pack.  
• Do not expose the battery terminal to any mechanical shock.  
Be careful not to attach the battery pack forcefully.  
• The following events may happen, if there is a battery pack on  
the unit. In that case, please contact your Sony dealer or local  
authorized Sony service facility.  
B
C
– The CHARGE lamp keeps blinking or does not light.  
– Your video equipment does not work with a full-charged  
battery pack.  
Do not connect the battery charger to a voltage adaptor  
(travel converter) for overseas travel. This may result in  
overheating or other malfunction.  
• Be sure that nothing metallic comes into contact with the metal  
parts of the unit. If it does, a short may occur and the unit may  
be damaged.  
Wh e re n o t t o p la ce t h is u n it  
Regardless of whether this unit is in use or in storage, do not  
place it in any of the following locations. Doing so may lead to  
breakdown.  
Sp e cifica t io n s  
Input rating  
100 - 240 V AC, 50/ 60 Hz, 5W  
Battery charge terminal:  
Output rating  
8.4 V DC, 0.3 A  
• Locations of extremely high temperature  
Operating temperature  
Storage temperature  
Dimensions  
0°C to + 40°C (32°F to 104°F)  
–20°C to + 60°C (–4°F to 140°F)  
Approx. 47 × 27 × 70 mm (w/ h/ d)  
(1 7/ 8 × 1 1/ 8 × 2 7/ 8 inches)  
Approx. 70 g (2.5 oz)  
The temperature gets extremely high inside a car with the  
windows closed in summer or in strong sunshine, and leaving  
the unit inside may cause it to be deformed or break down.  
• In direct sunlight or near a heater  
Mass  
There is a risk of deformation or breakdown.  
• Locations of excessive vibration  
Design and specifications are subject to change without notice.  
• Locations with strong electromagnetism or radiant rays  
• Locations with excessive sand  
In locations such as the seashore and other sandy areas or  
where dust clouds occur, protect the unit from sand and dust.  
Printed on 100% recycled paper using  
VOC (Volatile Organic Compound)-free  
vegetable oil based ink.  
There is a risk of breakdown.  
 

Acer Network Card AcceleRAID 170 User Manual
Acoustic Research Headphones ART7 User Manual
ADC Clothes Dryer UD 50 User Manual
Agri Fab Spreader 45 03881 User Manual
American DJ DJ Equipment DP 8A User Manual
Axis Communications Security Camera M1145 User Manual
Aztech Systems Modem DSL600EC User Manual
Badger Basket High Chair 01017 User Manual
Behringer Car Speaker B215XL B215XL WH User Manual
Behringer Mixer QX1002 User Manual