ADDONICS TECHNOLOGIES
Model: ADZIFCF
Installation Guide
1. Insert the desired Compact Flash into the Addonics 1.8"
Pin 1
ZIF - CF Adapter (ADZIFCF). The Compact Flash
should be keyed to prevent the card from being
incorrectly inserted.
CF Slot
Power and
Drive Activity
LED
Latch
Pin 1
ZIF connector
2. Put the mechanism in the open position and slide the
flat ribbon cable into the ZIF connector on the adapter.
Locking Mechanism on ZIF Connector
Open Position:
3. Close the latch to secure the ribbon cable connection.
1.8” ZIF- CF adapter shown below attached to a 1.8” ZIF
to 2.5” IDE converter
Latch
The locking mechanism on the ZIF connector is in the open
position if the latch faces vertical.
1.8” ZIF- CF adapter shown below connected to a 2.5”
drive enclosure
Close Position:
TECHNICAL SUPPORT
Latch
Email:
Internet:
The locking mechanism on the ZIF connector is in the close
position if the latch faces horizontal.
Technical Support (8:30 am to 6:00 pm PST)
Phone:
Email:
408 453-6212
Note: Instructions can be found on the FAQ section.
|